Peco PL-17 Probe For PL-18 stud point opperation

PL-17 Probe For PL-18 stud point opperation 

PROBE FOR OPERATING TURNOUT MOTORS

A simple yet effective method of switching turnouts. The PL-18 Studs are inserted into the control panel, often laid out as a layout diagram. A wire is then soldered to the tag at the back, which goes to the relevant solenoid of the turnout motor. When power is applied by touching the powered PL-17 probe on the stud the Turnout Motor is activated.

Recommended to be used with:

• PL-18 Studs and Washers
• PL-10 Turnout Motors